Show Table of Contents
12.8. Performing a Network Installation
If you are performing a network installation and booted with the
askmethod boot option, the Configure TCP/IP dialog appears. This dialog asks for your IP and other network addresses. You can choose to configure the IP address and Netmask of the device via DHCP or manually. If manually, you have the option to enter IPv4 and/or IPv6 information. Enter the IP address you are using during installation and press Enter. Note that you need to supply IPv4 information if you wish to perform an NFS installation.
Figure 12.5. TCP/IP Configuration
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.