Show Table of Contents
5.4. Issues with queue_if_no_path feature
If
features "1 queue_if_no_path" is specified in the /etc/multipath.conf file, then any process that issues I/O will hang until one or more paths are restored. To avoid this, set the no_path_retry N parameter in the /etc/multipath.conf file (where N is the number of times the system should retry a path).
When you set the
no_path_retry parameter, remove the features "1 queue_if_no_path" option from the /etc/multipath.conf file as well. If, however, you are using a multipathed device for which the features "1 queue_if_no_path" option is set as a compiled-in default, as it is for many SAN devices, you must explicitly add features "0" to override this default. You can do this by copying the existing devices section for your device from /usr/share/doc/device-mapper-multipath-0.4.7/multipath.conf.defaults into /etc/multipath.conf and editing it to suit your needs.
If you need to use the
features "1 queue_if_no_path" option and you experience the issue noted here, use the dmsetup command to edit the policy at runtime for a particular LUN (that is, for which all the paths are unavailable). For example, if you want to change the policy on the multipath device mpath2 from "queue_if_no_path" to "fail_if_no_path", execute the following command.
dmsetup message mpath2 0 "fail_if_no_path"
Note that you must specify the
mpathn alias rather than the path.
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.