Red Hat Training
A Red Hat training course is available for Red Hat Enterprise Linux
Chapter 7. Swap Space
7.1. What is Swap Space?
Swap space in Linux is used when the amount of physical memory (RAM) is full. If the system needs more memory resources and the RAM is full, inactive pages in memory are moved to the swap space. While swap space can help machines with a small amount of RAM, it should not be considered a replacement for more RAM. Swap space is located on hard drives, which have a slower access time than physical memory.
Swap space can be a dedicated swap partition (recommended), a swap file, or a combination of swap partitions and swap files.
In years past, the recommended amount of swap space increased linearly with the amount of RAM in the system. But because the amount of memory in modern systems has increased into the hundreds of gigabytes, it is now recognized that the amount of swap space that a system needs is a function of the memory workload running on that system. However, given that swap space is usually designated at install time, and that it can be difficult to determine beforehand the memory workload of a system, we recommend determining system swap using the following table.
Table 7.1. Recommended System Swap Space
|Amount of RAM in the System||Recommended Amount of Swap Space|
|4GB of RAM or less||a minimum of 2GB of swap space|
|4GB to 16GB of RAM||a minimum of 4GB of swap space|
|16GB to 64GB of RAM||a minimum of 8GB of swap space|
|64GB to 256GB of RAM||a minimum of 16GB of swap space|
|256GB to 512GB of RAM||a minimum of 32GB of swap space|
File systems and LVM2 volumes assigned as swap space cannot be in use when being modified. For example, no system processes can be assigned the swap space, as well as no amount of swap should be allocated and used by the kernel. Use the
cat /proc/swapscommands to verify how much and where swap is in use.
The best way to achieve swap space modifications is to boot your system in rescue mode, and then follow the instructions (for each scenario) in the remainder of this chapter. Refer to the Red Hat Enterprise Linux Installation Guide for instructions on booting into rescue mode. When prompted to mount the file system, select Skip.