-
Language:
English
-
Language:
English
Red Hat Training
A Red Hat training course is available for Red Hat Enterprise Linux
5.3. HP iLO Fence Device Configuration Procedure
This section provides the procedure for adding an HP iLO fence device to each node of cluster
hpiloclust
. Each node of hpiloclust
is managed by its own HP iLO management board.
Use the following procedure to configure the HP iLO management board as the fence device for node
clusternode1.example.com
using Conga:
- As an administrator of luci Select the cluster tab. This displays the Choose a cluster to administer screen.
- From the Choose a cluster to administer screen, you should see the previously configured cluster
hpiloclust
displayed, along with the nodes that make up the cluster. Click on clusternode1.example.com. This displays the configuration screen for nodeclusternode1.example.com
. - At the
Main Fencing Method
display, click Add a fence device to this level. This causes a dropdown manu to display. - From the dropdown menu, under Create a new Fence Device, select HP iLO. This displays a fence device configuration menu, as shown in Figure 5.2, “Creating an HP iLO Fence Device”.
Figure 5.2. Creating an HP iLO Fence Device
- For Name, enter
hpilofence1
. - For Hostname, enter
hpilohost1
. - For Login, enter
hpilologin
. - For Password, enter
hpilopword
. - For Password Script, leave the field blank.
- For Use SSH, leave the field blank. You would check this box of your system uses SSH to access the HP iLO management board.
- Click Update main fence properties. This causes a confirmation screen to be displayed.
- On the confirmation screen, click OK. After the fence device has been added, a progress page is displayed after which the display returns to the configuration page for
clusternode1.example.com
in clusterhpiloclust
.
After configuring an HP iLO fence device for
clusternode1.example.com
, use the following procedure to configure an HP iLO fence device for clusternode2.example.com
.
- From the configuration page for
clusternode1.example.com
, a menu appears on the left of the screen for clusterhpiloclust
. Select the nodeclusternode2.example.com
. The configuration page forclusternode2.example.com
appears, with no fence device configured. - At the
Main Fencing Method
display, click Add a fence device to this level. This causes a dropdown manu to display. - From the dropdown menu, under Create a new Fence Device, select HP iLO. This displays a fence device configuration menu.
- For Name, enter
hpilofence2
. - For Hostname, enter
hpilohost2
. - For Login, enter
hpilologin
. - For Password, enter
hpilopword
. - For Password Script, leave the field blank.
- For Use SSH, leave the field blank.
- Click Update main fence properties. This causes a confirmation screen to be displayed.
- On the confirmation screen, click OK. After the fence device has been added, a progress page is displayed after which the display returns to the configuration page for
clusternode1.example.com
in clusterhpiloclust
.
After configuring
hpilofence2
as the fencing device for clusternode2.example.com
, select node clusternode3.example.com
from the menu on the left side of the page and configure an HP iLO fence device for that node using the same procedure as you did to configure the fence devices for clusternode2.example.com
and clusternode3.example.com
. For clusternode3.example.com
, use hpilofence3
as the name of the fencing method and hpilohost3
as the host name. Otherwise, use the same values for the fence device parameters.