Show Table of Contents
36.4. Performing the Upgrade
After retrieving all of the necessary packages, it is time to upgrade the existing kernel. At a shell prompt, as root, change to the directory that contains the kernel RPM packages and follow these steps.
It is strongly recommended that the old kernel is kept in case there are problems with the new kernel.
-iargument with the
rpmcommand to keep the old kernel. Do not use the
-Uoption, since it overwrites the currently installed kernel, which creates boot loader problems. Issue the following command (the kernel version may vary):
rpm -ivh kernel-2.6.9-5.EL.<arch>.rpm
If the system is a multi-processor system, install the
kernel-smppackages as well (the kernel version may vary):
rpm -ivh kernel-smp-2.6.9-5.EL.<arch>.rpm
If the system is
i686-based and contains more than 4 GB of RAM, install the
kernel-hugemempackage built for the
i686architecture as well (the kernel version might vary):
rpm -ivh kernel-hugemem-2.6.9-5.EL.i686.rpm
The next step is to verify that the initial RAM disk image has been created. Refer to Section 36.5, “Verifying the Initial RAM Disk Image” for details.