22.214.171.124. Configuring ssh-agent
ssh-agentcan be used to store your passphrase so that you do not have to enter it each time you make a
scpconnection. If you are not running the X Window System, follow these steps from a shell prompt. If you are running GNOME but you do not want to configure it to prompt you for your passphrase when you log in (refer to Section 126.96.36.199, “Configuring
ssh-agentwith GNOME”), this procedure will work in a terminal window, such as an XTerm. If you are running X but not GNOME, this procedure will work in a terminal window. However, your passphrase will only be remembered for that terminal window; it is not a global setting.
- At a shell prompt, type the following command:
exec /usr/bin/ssh-agent $SHELL
- Then type the command:
ssh-addand enter your passphrase(s). If you have more than one key pair configured, you will be prompted for each one.
- When you log out, your passphrase(s) will be forgotten. You must execute these two commands each time you log in to a virtual console or open a terminal window.