At first glance,
iptables appear to be quite similar. Both methods of packet filtering use chains of rules operating within the Linux kernel to decide what to do with packets that match the specified rule or set of rules. However,
iptables offers a more extensible way of filtering packets, giving the administrator a greater amount of control without building a great deal of complexity into the system.
Specifically, users comfortable with
ipchains should be aware of the following significant differences between
iptables before attempting to use
iptables, each filtered packet is processed using rules from only one chain rather than multiple chains. For instance, a FORWARD packet coming into a system using
ipchains would have to go through the INPUT, FORWARD, and OUTPUT chains to move along to its destination. However,
iptables only sends packets to the INPUT chain if they are destined for the local system and only sends them to the OUTPUT chain if the local system generated the packets. For this reason, it is important to place the rule designed to catch a particular packet within the rule that actually handles the packet.
The DENY target has been changed to DROP. In
ipchains, packets that matched a rule in a chain could be directed to the DENY target. This target must be changed to DROP under
Order matters when placing options in a rule. With
ipchains, the order of the rule options does not matter. The
iptables command uses stricter syntax. In
iptables commands, the protocol (ICMP, TCP, or UDP) must be specified before the source or destination ports.
When specifying network interfaces to be used with a rule, you must only use incoming interfaces (
-i option) with INPUT or FORWARD chains and outgoing interfaces (
-o option) with FORWARD or OUTPUT chains. This is necessary because OUTPUT chains are no longer used by incoming interfaces, and INPUT chains are not seen by packets moving through outgoing interfaces.
This is not a comprehensive list of the changes, given that
is a fundamentally rewritten network filter. For more specific information, refer to the Linux Packet Filtering HOWTO
referenced in Section 18.7, “Additional Resources”