Chapter 23. Performance tuning considerations with Business Central
The following key concepts or suggested practices can help you optimize Business Central configuration and Red Hat Decision Manager performance. These concepts are summarized in this section as a convenience and are explained in more detail in the cross-referenced documentation, where applicable. This section will expand or change as needed with new releases of Red Hat Decision Manager.
- Ensure that development mode is enabled during development
You can set Decision Server or specific projects in Business Central to use
developmentmode. By default, Decision Server and all new projects in Business Central are in development mode. This mode provides features that facilitate your development experience, such as flexible project deployment policies, and features that optimize Decision Server performance during development, such as disabled duplicate GAV detection. Use development mode until your Red Hat Decision Manager environment is established and completely ready for production mode.
For more information about configuring the environment mode or duplicate GAV detection, see the following resources:
- Disable verification and validation of complex guided decision tables
The decision table verification and validation feature of Business Central is enabled by default. This feature helps you validate your guided decision tables, but with complex guided decision tables, this feature can hinder decision engine performance. You can disable this feature by setting the
org.kie.verification.disable-dtable-realtime-verificationsystem property value to
For more information about guided decision table validation, see Designing a decision service using guided decision tables.
- Disable automatic builds if you have many large projects
In Business Central, when you navigate between projects in the Project Explorer side panel, the selected project is built automatically so that the Alerts window is updated to show any build errors for the project. If you have large projects or frequently switch between many projects that are under active development, this feature can hinder Business Central and decision engine performance.
To disable automatic project builds, set the
org.kie.build.disable-project-explorersystem property to