Language and Page Formatting Options
7.8. Default User Security Configuration
All management interfaces in JBoss Enterprise Application Platform 6 are secured by default. This security takes two different forms:
- Local interfaces are secured by a SASL contract between local clients and the server they connect to. This security mechanism is based on the client's ability to access the local filesystem. This is because access to the local filesystem would allow the client to add a user or otherwise change the configuration to thwart other security mechanisms. This adheres to the principle that if physical access to the filesystem is achieved, other security mechanisms are superfluous. The mechanism happens in four steps:
NoteHTTP access is considered to be remote, even if you connect to the localhost using HTTP.
- The client sends a message to the server which includes a request to authenticate with the local SASL mechanism.
- The server generates a one-time token, writes it to a unique file, and sends a message to the client with the full path of the file.
- The client reads the token from the file and sends it to the server, verifying that it has local access to the filesystem.
- The server verifies the token and then deletes the file.
- Remote clients, including local HTTP clients, use realm-based security. The default realm with the permissions to configure the JBoss Enterprise Application Platform 6 remotely using the management interfaces is
ManagementRealm. A script is provided which allows you to add users to this realm (or realms you create). For more information on adding users, refer to the Getting Started chapter of the Installation guide for JBoss Enterprise Application Platform 6. For each user, the username, a hashed password, and the realm are stored in a file. The file is in a different location if the JBoss Enterprise Application Platform 6 is configured as a managed domain or a standalone server.
Even though the contents of the
- Managed domain
- Standalone server
mgmt-users.propertiesare masked, the file should still be treated as a sensitive file. It is recommended that it be set to the file mode of
600, which gives no access other than read and write access by the file owner.