Show Table of Contents
6.3.2. Modify a Non-XA Datasource with the Management Interfaces
Summary
This topic covers the steps required to modify a non-XA datasource, using either the Management Console or the Management CLI.
Prerequisites
Note
Non-XA datasources can be integrated with JTA transactions. To integrate the datasource with JTA, ensure that the
jta parameter is set to true.
Procedure 6.5. Modify a Non-XA Datasource
Management CLI
- Use the
write-attributecommand to configure a datasource attribute:/subsystem=datasources/data-source=DATASOURCE_NAME:write-attribute(name=ATTRIBUTE_NAME,value=ATTRIBUTE_VALUE)
- Reload the server to confirm the changes:
:reload
Management Console
Navigate to the Datasources panel in the Management Console
- Select the Configuration tab from the top of the console.
- For Domain mode only, select a profile from the drop-down box in the top left.
- Expand the menu on the left of the console, then expand the menu.
- Select from expanded menu.
Edit the datasource
- Select a datasource from the Available Datasources list. The datasource attributes are displayed below.
- Click to edit the datasource attributes.
- Click to finish.
Result
The non-XA datasource has been configured. The changes are now visible in either the standalone.xml or domain.xml file, as well as the management interfaces.
- To create a new datasource, refer here: Section 6.3.1, “Create a Non-XA Datasource with the Management Interfaces”.
- To remove the datasource, refer here: Section 6.3.3, “Remove a Non-XA Datasource with the Management Interfaces”.
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.