6.4.2. Modify an XA Datasource with the Management Interfaces

Procedure 6.8. Modify an XA Datasource, Using Either the Management CLI or the Management Console

• • Management CLI

    1. Section 3.5.2, “Launch the Management CLI”.

    2. Configure XA datasource attributes

       Use the write-attribute command to configure a datasource attribute:

       /subsystem=datasources/xa-data-source=XA_DATASOURCE_NAME:write-attribute(name=ATTRIBUTE_NAME,value=ATTRIBUTE_VALUE)

    3. Configure XA datasource properties

       Run the following command to configure an XA datasource subresource:

       /subsystem=datasources/xa-data-source=DATASOURCE_NAME/xa-datasource-properties=PROPERTY_NAME:add(value=PROPERTY_VALUE)

    4. Reload the server to confirm the changes:

       :reload

  • Management Console

    1. Section 3.4.2, “Log in to the Management Console”.

    2. Navigate to the Datasources panel in the Management Console

       1. Select the Configuration tab from the top of the console.
       2. For Domain Mode only, select a profile from the drop-down box at top left.
       3. Expand the Subsystems menu on the left of the console, then expand the Connector menu.
       4. Select Datasources.
    3. Select the XA Datasource tab.

    4. Edit the datasource

       1. Select the relevant XA datasource from the Available XA Datasources list. The XA datasource attributes are displayed in the Attributes panel below it.
       2. Select the Edit button to edit the datasource attributes.
       3. Edit the XA datasource attributes and select the Save button when done.