9.2. Specify Which Network Interface JBoss EAP 6 Uses


Isolating services so that they are accessible only to the clients who need them increases the security of your network. JBoss EAP 6 includes two interfaces in its default configuration, both of which bind to the IP address, or localhost, by default. One of the interfaces is called management, and is used by the Management Console, CLI, and API. The other is called public, and is used to deploy applications. These interfaces are not special or significant, but are provided as a starting point.

The management interface uses ports 9990 and 9999 by default, and the public interface uses port 8080, or port 8443 if you use HTTPS.
You can change the IP address of the management interface, public interface, or both.


If you expose the management interfaces to other network interfaces which are accessible from remote hosts, be aware of the security implications. Most of the time, it is not advisable to provide remote access to the management interfaces.
  1. Stop JBoss EAP 6.

    Stop JBoss EAP 6 by sending an interrupt in the appropriate way for your operating system. If you are running JBoss EAP 6 as a foreground application, the typical way to do this is to press Ctrl+C.
  2. Restart JBoss EAP 6, specifying the bind address.

    Use the -b command-line switch to start JBoss EAP 6 on a specific interface.

    Example 9.1. Specify the public interface.

    EAP_HOME/bin/domain.sh -b

    Example 9.2. Specify the management interface.

    EAP_HOME/bin/domain.sh -bmanagement=

    Example 9.3. Specify different addresses for each interface.

    EAP_HOME/bin/domain.sh -bmanagement= -b

    Example 9.4. Bind the public interface to all network interfaces.

    EAP_HOME/bin/domain.sh -b
It is possible to edit your XML configuration file directly, to change the default bind addresses. However, if you do this, you will no longer be able to use the -bcommand-line switch to specify an IP address at run-time, so this is not recommended. If you do decide to do this, be sure to stop JBoss EAP 6 completely before editing the XML file.