Show Table of Contents
4.7. Service Configuration
4.7.1. Configure JBoss EAP 6 as a Service in Red Hat Enterprise Linux (RPM Method)
Prerequisites
- Install JBoss EAP 6 using the RPM Method (Graphical or Text Based).
- Administrator privileges on the server are required.
Summary
Use the following procedure to install JBoss EAP 6 as a service on Red Hat Enterprise Linux when the installation has been done using the RHN (RPM) method.
Procedure 4.11. Configure JBoss EAP 6 as a Service using the RPM Method in Red Hat Enterprise Linux
Install JBoss EAP 6
Install JBoss EAP 6 via the RPM method using one of the steps listed in the prerequisite sections listed above.Enable the service
The RPM install method for JBoss EAP 6 installs the requisite service files in their correct locations. All you need to do to set it up as service is issue the following command:chkconfig jbossas on
Result
JBoss EAP 6 starts automatically when the Red Hat Enterprise Linux reaches its default run-level, and stops automatically when the operating system goes through its shutdown routine.
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.