Procedure 6.8. Modify an XA Datasource, Using Either the Management CLI or the Management Console

• • Management CLI

    1. Section 3.5.2, “Launch the Management CLI”.

    2. Configure XA datasource attributes

       Use the write-attribute command to configure a datasource attribute:

       /subsystem=datasources/xa-data-source=XA_DATASOURCE_NAME:write-attribute(name=ATTRIBUTE_NAME,value=ATTRIBUTE_VALUE)

    3. Configure XA datasource properties

       Run the following command to configure an XA datasource subresource:

       /subsystem=datasources/xa-data-source=DATASOURCE_NAME/xa-datasource-properties=PROPERTY_NAME:add(value=PROPERTY_VALUE)

    4. Reload the server to confirm the changes:

       :reload

  • Management Console

    1. Section 3.4.2, “Log in to the Management Console”.

    2. Navigate to the Datasources panel in the Management Console

       1. • Standalone Mode

            Select the Profile tab from the top of the console.

          • Domain Mode

            1. Select the Profiles tab from the top of the console.
            2. Select the appropriate profile from the drop-down box in the top left.
            3. Expand the Subsystems menu on the left of the console.
       2. Select Connector → Datasources from the menu on the left of the console.
    3. Select the XA Datasource tab.

    4. Edit the datasource

       1. Select the relevant XA datasource from the Available XA Datasources list. The XA datasource attributes are displayed in the Attributes panel below it.
       2. Select the Edit button to edit the datasource attributes.
       3. Edit the XA datasource attributes and select the Save button when done.