Red Hat Training

A Red Hat training course is available for Red Hat Fuse

Chapter 3. Install JBoss Fuse on JBoss EAP

Prerequisites

JBoss Fuse must be installed on JBoss EAP 6.4. If you need to install JBoss EAP 6.4, download it from JBoss EAP 6.4 Installer Download. See JBoss EAP 6.4 Installation Guide for installation instructions.
Important
We also recommend that you apply the latest patch to JBoss EAP 6.4. The JBoss EAP patch level should be at least 6.4.7, to avoid known issues. Patches are available from the JBoss EAP 6.4 Patches tab of the download page.

Install JBoss Fuse using Installer

  1. Download Red Hat JBoss Fuse 6.2.1 on EAP Installer to a temporary location on your file system.
  2. Navigate to $EAP_HOME of a clean instance of JBoss EAP.
  3. Run the installer with the following command: 
    java -jar temporary location/fuse-eap-installer-6.2.1.redhat-084.jar
Note
Once a datastore has been has been selected at installation, it can not be changed.