8.6.3. Approving a Hypervisor
Summary
It is not possible to run virtual machines on a Hypervisor until the addition of it to the environment has been approved in Red Hat Enterprise Virtualization Manager.
Procedure 8.25. Approving a Hypervisor
- Log in to the Red Hat Enterprise Virtualization Manager Administration Portal.
- From the Hosts tab, click on the host to be approved. The host should currently be listed with the status of Pending Approval.
- Click the Approve button. The Edit and Approve Hosts dialog displays. You can use the dialog to set a name for the host, fetch its SSH fingerprint before approving it, and configure power management, where the host has a supported power management card. For information on power management configuration, see the Power Management chapter of the Red Hat Enterprise Virtualization Administration Guide.
- Click . If you have not configured power management you will be prompted to confirm that you wish to proceed without doing so, click .
Result
The status in the Hosts tab changes to Installing, after a brief delay the host status changes to Up.