B.3. Configuring an Apache HTTP Server in a Red Hat High Availability Cluster with the pcs Command

This section describes how to configure an Apache HTTP server in a two-node Red Hat Enterprise Linux High Availability Add-On cluster using pcs to configure cluster resources. In this example case, clients access Apache through a floating IP address. The web server runs on one of two nodes in the cluster. If the node on which the web server is running becomes inoperative, the web server starts up again on the second node of the cluster with minimal service interruption.
This example requires that your system include the following components:
  • A 2-node Red Hat High Availability cluster with power fencing configured for each node. This procedure uses the cluster example provided in Section B.1.2, “Creating and Starting the Cluster”.
  • A public virtual IP address, required for Apache.
  • Shared storage for the nodes in the cluster, using iSCSI or Fibre Channel.
The cluster is configured with an Apache resource group, which contains the cluster components that the web server requires: an LVM resource, a file system resource, an IP address resource, and a web server resource. This resource group can fail over from one node of the cluster to the other, allowing either node to run the web server. Before creating the resource group for this cluster, you will perform the following procedures:
  1. Configure an ext4 file system mounted on the logical volume my_lv, as described in Section B.3.1, “Configuring an LVM Volume with an ext4 File System”.
  2. Configure a web server, as described in Section B.3.2, “Web Server Configuration”.
  3. Ensure that only the cluster is capable of activating the volume group that contains my_lv, and that the volume group will not be activated outside of the cluster on startup, as described in Section B.3.3, “Exclusive Activation of a Volume Group in a Cluster”.
After performing these procedures, you create the resource group and the resources it contains, as described in Section B.3.4, “Creating the Resources and Resource Groups with the pcs Command”.

B.3.1. Configuring an LVM Volume with an ext4 File System

This example requires that you create an LVM logical volume on storage that is shared between the nodes of the cluster.
The following procedure creates an LVM logical volume and then creates an ext4 file system on that volume. In this example, the shared partition /dev/sdb1 is used to store the LVM physical volume from which the LVM logical volume will be created.

Note

LVM volumes and the corresponding partitions and devices used by cluster nodes must be connected to the cluster nodes only.
Since the /dev/sdb1 partition is storage that is shared, you perform this procedure on one node only,
  1. Create an LVM physical volume on partition /dev/sdb1.
    # pvcreate /dev/sdb1
      Physical volume "/dev/sdb1" successfully created
    
  2. Create the volume group my_vg that consists of the physical volume /dev/sdb1.
    # vgcreate my_vg /dev/sdb1
      Volume group "my_vg" successfully created
    
  3. Create a logical volume using the volume group my_vg.
    # lvcreate -L450 -n my_lv my_vg
      Rounding up size to full physical extent 452.00 MiB
      Logical volume "my_lv" created
    
    You can use the lvs command to display the logical volume.
    # lvs
      LV      VG      Attr      LSize   Pool Origin Data%  Move Log Copy%  Convert
      my_lv   my_vg   -wi-a---- 452.00m
      ...
    
  4. Create an ext4 file system on the logical volume my_lv.
    # mkfs.ext4 /dev/my_vg/my_lv
    mke2fs 1.42.7 (21-Jan-2013)
    Filesystem label=
    OS type: Linux
    ...