The operating system determines the exact steps using to complete the installation of Fuse ESB Enterprise as a service. The wrapper:install command provides basic instructions for your operating system.

To install the service run InstallDir\bin\ServiceName-service.bat install. If you used the default start setting, the service will start when Windows is launched. If you specified DEMAND_START, you will need to start the service manually.

To start the service manually run net start "ServiceName". You can also use the Windows service UI.

To manually stop the service run net stop "ServiceName" You can also use the Windows service UI.

You remove the installed the service by running InstallDir\bin\ServiceName-service.bat remove.

To install the service and configure it to start when the machine boots, run the following commands:

# ln -s InstallDir\bin\ServiceName-service /etc/init.d/
# chkconfig ServiceName-service --add
# chkconfig ServiceName-service on

To start the service manually run service ServiceName-service start.

To manually stop the service run service ServiceName-service stop.

You remove the installed the service by running the following commands:

#service ServiceName-service stop
# chkconfig ServiceName-service --del
# rm /etc/init.d/ServiceName-service

To install the service and configure it to start when the machine boots, run the following commands:

# ln -s InstallDir\bin\ServiceName-service /etc/init.d/
# update-rc.d ServiceName-service defaults

To start the service manually run /etc/init.d/ServiceName-service start.

To manually stop the service run /etc/init.d/ServiceName-service stop.

You remove the installed the service by running the following commands:

#/etc/init.d/ServiceName-service stop
# rm /etc/init.d/ServiceName-service