Red Hat DocumentationFuse ESBToggle FramesPrintFeedback

Build and Run the Demonstration

Steps to run the demonstration

Perform the following steps to build and run the demonstration:

  1. If you have not already done so, start up the STS as follows. Open a new command prompt, change directory to samples/sts_issue_operation, and enter the following Maven command:

    mvn jetty:run
  2. Build and start up the WS server. Open a new command prompt, change directory to samples/wsdl_first_https, and enter the following Maven command:

    mvn -Pserver

    Note

    The server is programmed to time out after five minutes.

  3. Build and run the WS client. Open a new command prompt, change directory to samples/wsdl_first_https, and enter the following Maven command:

    mvn -Psecure.client
Comments powered by Disqus