RHEV (3.5) - How can I add additional NICs to create a new network?
Hi,
I am running RHEV 3.5 in my lab with currently 4 hypervisors attached. The VMs are using the rhevm network. I added an extra NIC on each hypervisor but cannot configure those NICs because they are now managed my RHEV-M.
I cannot figure out how to test and configure those interfaces from within RHEV manager.
Any help is appreciated.
Responses
Active Contributor
392 points
Have you created the logical network for your cluster?
Data Center -> Clusters -> Logical Networks -> New
Have you configured your hosts' network interfaces to utilize the newly created logical network?
Data Center -> Hosts -> Network Interfaces -> Setup Host Networks -> Drag interface (ex. eth0) to new network
This will enable your hosts to utilize the new network. If you want your guests to be able to utilize it, then the network will need to be designated as a VM network. This can be done accomplished at network creation time or later.
Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.