Attempting to install Red Hat Enterprise Linux 5 on a Megaraid-based system fails, as the system cannot detect the Megaraid driver. How do I work around this?

Updated -

If the BIOS settings for the adapter is incorrectly set to "I2O" emulation, the system will attempt to load the i2o driver. This will fail, and prevent the proper driver from being loaded. To prevent an installation failure on a Megaraid-based system, the correct emulation mode must be used.

Host bus adapters that use the MegaRAID driver must be set to operate in "Mass Storage" emulatio...

Subscriber exclusive content

A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.

Current Customers and Partners

Log in for full access

Log In