Reading NFS rpcdebug output and mapping to a network trace

Updated -

Introduction

This article describes a way to use two specific lines of rpcdebug output in conjunction with a tcpdump to match up NFS client code execution to a tcpdump.

Setting rpcdebug flags

For purposes of this article, only a couple rpcdebug lines are used. In practice to debug a real problem, other lines of rpcdebug or other instrumentation may be required. Note ...

Subscriber exclusive content

A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.

Current Customers and Partners

Log in for full access

Log In
Close

Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.